_ I am far from a guru, I'm barely a novice. 8 hours later only 55 blocks out of 235 (i think) had been erased. I got it to erase, nvram, cfe but erasing kernel hangs.īefore going to bed last night I started erase:wholeflash.
Download Lagu Barat Lama Romantis Gratis. Same as yours except the Mac, serial and pin. Malachi DD-WRT Guru Joined: Posts: 6640 Location: Columbus, Ohio Posted: Thu 17:51 Post subject: I backed up my cfe, twice. If the connection works for you, they should be almost identical. On a second thought, you may try to backup the cfe and binary compare with the cfe I have posted. Erase: nvram or backup:nvram din not work for me. Follow the on-screen instructions to complete your router setup. Click Set up your Linksys Router If you do not see this: For Windows, click Start, Computer, then double-click the CD drive and the Setup icon For Mac, double-click the CD icon on your desktop, then double-click the Setup icon 3. I have successfully backed up the CFE and the NVRAM from a second E4200v1 that I have, therefore I'am pretty sure it should work for you too, if you have the same Winbond flash chip. Insert the CD into your CD or DVD drive 2. You should get a NVRAM, corrupted probably, but looking close to what a NVRAM should look like. Alins75 DD-WRT Novice Joined: Posts: 12 Posted: Thu 17:46 Post subject: Before trying to erase, can you try to make a backup of the NVRAM, just to make sure the brjtag works? Try step 1, then step 7. Malachi DD-WRT Guru Joined: Posts: 6640 Location: Columbus, Ohio Posted: Wed 22:06 Post subject: I can't erase the nvram using either one of the two steps.
Init Arena Init Devs.ĭownload Free Software Versacheck Quicken Template Gallery. Of course I have tried and apparently it worked, but after reboot the only thing it did was to constantly show the following message on the serial console: (some of you may have seen it - the reboot loop) CFE version 2010.09.20.0 based on BBP 1.0.37 for BCM947XX (32bit,SP,LE) Build Date: Fri Nov 12 11:01: Copyright (C) 2000-2008 Broadcom Corporation. The bad thing was that I could not unbrick it with a serial connection and TFTP.
I have managed to brick my E4200 after flashing dd-wrt.v24-23082_NEWD-2_K2. Benryanau wrote: Updated with serial pinout, more JTAG info and pics. The yellow light flashes to indicate network activity over that port.Īuthor Message alins75 DD-WRT Novice Joined: Posts: 12 Posted: Mon 11:36 Post subject: HOWTO - unbrick Linksys E4200 v1 with JTAG Hi everybody, This is a small HOWTO that you can use to unbrick the E4200 using JTAG. I believe the E4200 has the common Linksys Jtag pinout. Linksys E4200 Chapter 1: Product Overview Back Ethernet 1-4 (yellow and green) Using Ethernet cables (also called network cables), these Ethernet ports connect the router to computers and other Ethernet network devices on your wired network. Get support for Linksys Linksys E4200 Maximum Performance Dual-Band N Router. Of which 142 are Linksys devices Default login user.